Back to Training

How Do You Bench Press Properly?

Mens Health Guide Editorial 6 March 2026

The bench press is the most performed and most frequently mangled exercise in most gyms. Done well, it builds the chest, shoulders and triceps effectively. Done with flared elbows and loose shoulders, it is a reliable route to shoulder pain. The setup does most of the work.

How should you set up?

Lie on the bench with your eyes roughly under the bar. Plant your feet flat on the floor, wider than the bench, with your shins roughly vertical or slightly behind your knees.

Pull your shoulder blades together and down, as though tucking them into your back pockets, and hold that position throughout the set. This creates a stable base, shortens the range of motion slightly and protects the shoulder joint.

A small natural arch in the lower back is normal and helpful. Your head, upper back and buttocks stay in contact with the bench and your feet stay on the floor.

What grip width should you use?

A common starting point places the forearms roughly vertical when the bar touches the chest. For most men that means gripping around one and a half times shoulder width.

Wider grips shorten the range and emphasise the chest but place more stress on the shoulders. Narrower grips emphasise the triceps and are often more comfortable for men with shoulder issues.

Grip the bar low in the palm, close to the wrist, so the wrist stays stacked rather than bent back.

Where should the bar touch?

Lower the bar to the lower chest, around the base of the sternum or slightly below the nipple line. Touching too high, near the collarbones, forces the elbows to flare and loads the shoulders.

The bar should not travel straight down. It moves in a slight arc from above the shoulders at lockout to the lower chest at the bottom.

What about elbow position?

Keep elbows at roughly forty-five to seventy-five degrees from the torso rather than flared to ninety. Fully flared elbows are the most common cause of bench-related shoulder pain.

Tucking excessively, towards the sides, turns it into a triceps-dominant lift and can strain the elbows.

How do you press?

Take a breath, brace the midsection, lower the bar under control for one to two seconds, touch the chest without bouncing, then drive back up while keeping the shoulder blades pinned.

Think about pushing yourself away from the bar rather than pushing the bar away from you. Keep the leg drive: pushing your feet into the floor stabilises the whole lift.

Keep the bar over the wrists rather than letting it drift towards the fingers, which strains the wrists and shifts the load forward.

How do you train safely alone?

Always use safety bars or pins set just above chest height when benching without a spotter. Getting pinned under a loaded bar is a genuine danger, and people have died this way.

If no safeties are available, use dumbbells instead, or do not use collars so plates can slide off in an emergency. Never bench heavy alone in a home gym without a rack with safeties.

How many sets and reps?

Three to five sets of three to eight repetitions suits strength, and three to four sets of eight to twelve suits size. Pressing twice a week, with one heavier and one lighter session, works well for most men.

What are the common faults?

Bouncing the bar off the chest, losing shoulder blade position, lifting the hips off the bench, uneven lockout, and wrists bent backwards all reduce effectiveness or increase risk.

Filming a set from the side shows most of these immediately.

What if it hurts your shoulder?

Try a narrower grip, more elbow tuck, reduced range using a board or paused technique, or switch to dumbbells, which allow a more natural path. Incline pressing is often more comfortable.

Seek advice for shoulder pain that persists between sessions, night pain, or weakness rather than simply discomfort.

You can browse more articles like this in our training section.

This page is general information rather than individual training or medical advice.