The deadlift has a reputation for destroying backs that it does not really deserve. It trains more muscle mass than almost any other exercise and carries directly into everyday lifting. Most injuries come from poor setup, excessive load or fatigue rather than from the movement itself, and all three are controllable.
How should you set up?
Stand with the bar over the middle of your foot, roughly an inch from your shins, with feet around hip-width apart and toes slightly out.
Bend forward and grip the bar just outside your legs. Then bend your knees until your shins touch the bar, without letting the bar roll forward. Lift your chest and flatten your back.
Your hips should sit between a squat and a bent-over position. Hips too low turns it into a poor squat; hips too high strains the lower back.
How do you brace and engage the lats?
Take a breath into your abdomen and tighten your midsection hard. Then pull your shoulder blades down and think about squeezing oranges in your armpits. This engages the lats and keeps the bar close, which is the single most important factor in keeping the back safe.
Take the slack out of the bar before pulling: pull up gently until you hear or feel the plates settle, then drive.
What does the pull look like?
Push the floor away with your legs rather than yanking with your back. The bar should travel in a straight vertical line, dragging lightly up the shins and thighs.
Hips and shoulders should rise together. If your hips shoot up first and the bar drifts forward, the weight is usually too heavy or the setup was wrong.
Finish by standing tall with hips fully extended. Do not lean back or hyperextend at the top, which places unnecessary stress on the lower back.
How do you lower it?
Push the hips back first, keeping the bar close, then bend the knees once the bar passes them. Control the descent without dropping, unless you are lifting heavy on suitable flooring where lowering under control is unsafe or impractical.
What grip should you use?
A double overhand grip is the default and limits how much you can hold, which is useful for building grip. As weights increase, options include a hook grip, gripping the thumb under the fingers, or a mixed grip with one hand over and one under.
Mixed grip allows more weight but creates asymmetry, so alternate hands between sets. Straps are appropriate on heavy volume work when grip limits training of the back and legs.
Which variation should you use?
Conventional suits most people. Sumo, with a wide stance and hands inside the legs, reduces the demand on the lower back and suits some hip structures.
The trap bar, or hex bar, places the load in line with your body and is the easiest to learn, with less lower back stress. It is an excellent option for general strength, for older lifters and for anyone with a history of back trouble.
What are the main faults?
Rounding of the lower back under load is the one that causes injuries. A slightly rounded upper back is common in experienced lifters; a rounded lumbar spine is not.
Letting the bar drift away from the body multiplies the force on the back. Jerking the bar off the floor without taking out the slack is another common cause of tweaks.
Should you use a belt?
Learn to brace without one first. Once you are lifting heavy, a belt increases intra-abdominal pressure and usually allows slightly more weight with better position. It is a tool for heavy sets rather than something to wear all session.
How often should you deadlift?
Once or twice a week is plenty. It is fatiguing, and most people progress well on relatively low volume, such as three to five sets of three to six repetitions.
Stop and seek advice for sharp back pain, pain radiating down a leg, or numbness and tingling. See a GP urgently for loss of bladder or bowel control or numbness around the groin.
The training section covers related topics in more detail.
This page is general information rather than individual training or medical advice.