The squat is one of the most effective exercises available and one of the most over-complicated. The core of it is straightforward: brace, sit down between your feet, stand back up. A handful of details separate a productive lift from a sore lower back, and most faults trace back to two or three causes.
How should you set up?
Set the bar in the rack at roughly mid-chest height, so you do not have to rise onto your toes to unrack it. Always use safety bars or pins set just below your lowest squat position when training alone.
Position the bar on your upper back. High bar means resting it on the shelf formed by the upper traps, which suits a more upright torso. Low bar sits slightly lower across the rear deltoids and allows more weight but more forward lean. Either is fine; high bar is easier to learn.
Grip the bar firmly, pull your elbows down and squeeze your shoulder blades together to create a solid shelf. Step under, stand up, take one or two steps back, and set your feet.
What stance should you use?
Roughly shoulder-width, with toes turned out around fifteen to thirty degrees. This varies with hip anatomy, and there is no universal ideal. If you feel pinching at the hip or cannot reach depth, experiment with a slightly wider stance or more toe-out.
How do you brace?
Take a breath into your abdomen rather than your chest, then tighten your midsection as though you are about to be punched. Hold that pressure throughout the repetition and breathe out at the top.
Bracing stabilises the spine and is the single most important safety element on heavy sets.
What does the descent look like?
Break at the hips and knees together, sitting down rather than only backwards. Keep the bar travelling over the middle of your foot throughout, which keeps you balanced.
Knees should track in line with your toes. Slight inward movement at the deepest point is common and not automatically a problem, but obvious collapse inwards under load needs addressing.
Control the descent for around two seconds rather than dropping.
How deep should you go?
Aim for the hip crease to reach at least parallel with the top of the knee, and deeper if you can maintain a neutral spine and heels flat.
Depth beyond the point where your pelvis tucks under, sometimes called butt wink, is counterproductive. Find the depth at which your back stays neutral and use that consistently.
What are the common faults?
Heels lifting usually indicates ankle mobility limitations. Weightlifting shoes with a raised heel, or a small plate under the heels, solves this immediately while mobility improves.
Excessive forward lean often reflects weak quads or a bar position issue, and frequently improves with front squats or high bar work.
Rounding of the lower back at the bottom is the fault that most needs fixing. Reduce depth or weight until you can hold position.
Rising with the hips first, leaving the bar behind, usually means the weight is too heavy or the quads are the limiting factor.
How do you start?
Learn with bodyweight squats, then goblet squats holding a dumbbell or kettlebell at the chest, which naturally encourages an upright torso. Move to the barbell once the pattern is comfortable.
How many sets should you do?
Three to five working sets on the main squat variation, once or twice a week, suits most people. Higher frequency helps technique in the early stages, since the squat is a skill as much as a strength exercise.
What if squatting hurts?
Pain in the knees, hips or lower back is a signal to change something rather than push on. Options include reducing depth, adjusting stance, switching to front squats, split squats, leg press or hack squat.
Stop and seek advice for sharp pain, pain that persists after training, or any numbness or tingling down the leg.
For related reading, see the rest of the training section.
This page is general information rather than individual training or medical advice.