Overhead pressing has spent years being labelled dangerous for the shoulders, which is unfair. It builds the shoulders, upper back and arms effectively and carries into anything involving lifting above head height. Problems arise when mobility is insufficient or technique is poor, and both can be addressed.
What does pressing overhead require?
To press safely, you need enough shoulder flexion to get the arms overhead without compensating, enough thoracic extension to avoid arching the lower back, and the ability to brace so force transfers from the floor.
Men with stiff upper backs and tight lats often cannot reach a true overhead position, so they arch the lower back instead. That is where the trouble starts.
How do you check your mobility?
Stand with your back against a wall, heels a few inches out, and press your lower back flat. Raise your arms overhead and try to touch the wall with the backs of your hands while keeping the back flat.
If you cannot, work on thoracic extension and lat flexibility, and use variations that do not require full overhead range in the meantime.
How should you set up?
Take the bar from a rack at upper chest height rather than cleaning it from the floor. Grip slightly wider than shoulder width, with the bar resting on the front deltoids and upper chest, elbows slightly in front of the bar.
Stand with feet hip to shoulder-width apart. Squeeze the glutes and brace the abdomen hard. This prevents the lower back arching as the bar goes overhead.
What does the movement look like?
Take a breath, brace, and press the bar in a straight vertical line. Because the head is in the way, move your head back slightly to let the bar pass, then push your head and chest forward through the gap as the bar clears.
Finish with the bar over the middle of the foot, directly above the shoulders, elbows locked, with the head in a neutral position, not pushed forward.
Lower under control back to the front deltoids, returning the head out of the way.
What are the common faults?
Excessive lower back arch is the main one, usually caused by limited shoulder mobility or weak bracing. It shifts the lift from a press to an incline press and loads the lumbar spine.
Pressing the bar forward rather than up puts the load in front of the body and stresses the shoulders. Leaving the head forward means the bar travels around it rather than through.
Flaring the elbows out to the sides at the start reduces power and increases shoulder stress.
What variations help?
Dumbbell overhead pressing allows a more natural path and each arm to move independently, which often removes pain.
Landmine pressing, with one end of a barbell in a corner or landmine attachment, is pressed at an angle rather than fully overhead. It is an excellent option for men with mobility limitations or shoulder issues.
Seated pressing with back support removes the bracing demand, though it also removes much of the core benefit. High incline dumbbell pressing is another useful substitute.
Is strict pressing better than push press?
Strict pressing builds shoulder strength with no leg contribution and is the better default. A push press, using a small dip and drive from the legs, allows heavier loads and is useful for overload once technique is solid.
How do you programme it?
Once or twice a week, three to five sets of five to ten repetitions. Progress is slower than on other lifts because the muscles involved are small, so expect small increments.
Training the upper back, rear deltoids and rotator cuff alongside pressing keeps the shoulder balanced and reduces problems.
When should you stop?
Pinching pain at the front or top of the shoulder during the movement is a signal to change the exercise, not to push through. Seek advice for shoulder pain that persists between sessions, wakes you at night, or comes with weakness.
More on this subject, and related ones, sits in the training section.
This page is general information rather than individual training or medical advice.