A one-rep max, the heaviest weight you can lift once with good technique, is used to set training percentages and to measure progress. Actually testing one carries risk, produces significant fatigue and is unnecessary for most people. In most cases, estimating is the better option.
Do you need to know it?
If you compete in powerlifting or follow a programme written in percentages, yes. Otherwise, probably not.
Many effective programmes use repetition targets and autoregulation instead, where you select weight based on how hard sets feel on the day. That approach adapts to sleep, stress and fatigue in a way fixed percentages cannot.
How do you estimate it instead?
Take a set of three to five repetitions close to failure and use a standard formula. One common version estimates your maximum as the weight multiplied by the number of repetitions, divided by thirty, plus the weight.
So eight repetitions with one hundred kilograms estimates a maximum of around 127 kilograms.
Accuracy is good for sets up to around five repetitions and declines as repetitions increase, because endurance becomes a larger factor. Most gym apps calculate this automatically.
How often should you test?
At most every eight to twelve weeks, and only at the end of a training block when you are fresh rather than in the middle of hard training.
Testing frequently costs more in recovery and lost training time than the information is worth.
How do you test safely?
Test only on lifts where failure is manageable: squat and bench press in a rack with safety bars set correctly, or deadlift, where you can simply fail to lift the bar.
Never test a bench press without safety bars or a competent spotter. Never test overhead press to failure standing under the bar.
Warm up thoroughly and ramp gradually. A typical progression might be five repetitions at forty per cent, three at sixty, two at seventy-five, one at eighty-five, one at ninety-two, then attempts.
Take three to five minutes between heavy singles. Make small jumps as you approach your limit, typically two and a half to five kilograms.
Stop when technique breaks down. A maximum with a rounded back or a bar dumped on safeties is not a useful number.
What is RPE?
Rate of perceived exertion is a scale used to judge effort. In lifting, it is usually expressed as repetitions in reserve: an RPE of eight means you could have done two more repetitions.
Using RPE allows you to auto-regulate. On a good day, the weight at a given effort is higher; on a bad day, lower. This is safer and often more productive than chasing percentages of a max set months ago.
What affects your maximum day to day?
Sleep, stress, food, hydration, time of day, caffeine and accumulated training fatigue all shift maximal strength, sometimes by five to ten per cent. A disappointing test may say more about the week than about your training.
What should you do with the number?
Use it to set training weights, typically working between sixty-five and eighty-five per cent for most productive training, and to track long-term progress.
Avoid using it as a source of ego. Chasing personal bests weekly is how technique degrades and injuries happen.
What about rep maxes instead?
Testing a three or five repetition maximum gives most of the information with far less risk and fatigue. Many lifters use a heavy set of five as their benchmark, repeated every couple of months, and never test a true single at all.
Who should not test?
Beginners, anyone with less than six months of consistent training, anyone with an active injury, and anyone with uncontrolled high blood pressure or a heart condition, since maximal lifting causes sharp blood pressure spikes.
Check with a GP if you are unsure. Estimating from a heavier set of five is a perfectly good alternative.
For related reading, see the rest of the training section.
This page is general information rather than individual training advice.